SITEDRAIN™ HQ 240 - American Wick Drain Corporation

Document technical information

Format pdf
Size 243.4 kB
First found Nov 13, 2015

Document content analysis

Language
English
Type
not defined
Concepts
no text concepts found

Places

Transcript

SITEDRAIN HQ 240
™
americanwick.com
PREFABRICATED COMBINATION DRAINS
PRODUCT OVERVIEW
SITEDRAIN HQ 240 prefabricated combination drains combine our most popular low-profile sheet core with a high-profile core
into one product design. Constructed using a graduated, high flow capacity formed polystyrene drainage core, SITEDRAIN HQ
240 has a nonwoven filter fabric bonded to one side. The fabric prevents soil particles from entering the flow channels while
allowing water to freely enter the drainage core and flow to designated exits. SITEDRAIN HQ 240 has a core flange for connection to SITEDRAIN Sheet Drain products to provide a continuous and uninterrupted flow path for collected water. The result is a
highly cost-effective design alternative to costly pipe and stone systems.
ROLL SIZE: 2’ x 50’
Typical Property Values
ASTM Test Method
Unit of Measure
240
FABRIC
PP
Material 1
gpm/ft
150
Lpm/m2
6,113
lbs
115
N
512
lbs
320
kN
1.41
sieve
70
mm
0.21
D 4491
sec
2.2
D 4632
%
70
D 4355
% / 500 Hrs
70
Survivability
-
-
2
Water Flow Rate
D 4491
Grab Tensile Strength
D 4632
CBR Puncture Resistance
D 6241
Apparent Opening Size
D 4751
Permittivity
Grab Elongation
UV Resistance
AASHTO M 288-06
2
-1
CORE
Material 1
HIPS
Thickness
D 1777
Compressive Strength
D 1621
Flow Rate 3
D 4716
in
.44 / 1.0
mm
11 / 25.4
psf
9,000
kPa
431
gpm/ft
Lpm/m
21
261
1 - PP = Polypropylene; HIPS = High Impact Polystyrene
2 - AASHTO Designation: M 288-06 Standard Specification for Highway Applications; American Association of State Highway and Transportation Officials, 2006. Geotextile survivability classification from installation stresses in subsurface drainage applications.
3 - In-plane flow rate measured at 3,600 psf (172 kPa) compressive load and a hydraulic gradient of 0.1.
All technical information contained in this document is accurate as of time of publishing. AWD reserves the right to make changes to products and literature without
notice. Please refer to our website for the most current technical information available. Unless otherwise stated, all physical and performance properties listed are
Typical Values as defined in ASTM D 4439.
1209 Airport Road, Monroe, NC 28110 • TF 800.242.WICK • PH 704.238.9200
2014 SD.HQ240
×

Report this document