Tender text

Document technical information

Format docx
Size 26.0 kB
First found May 22, 2018

Document content analysis

Language
English
Type
not defined
Concepts
no text concepts found

Persons

Organizations

Places

Transcript

Tender text
F.01U.317.536; FCS-8000-VFD-B;
AVIOTEC IP starlight 8000
Network camera with integrated video-based fire detection and
simultaneous intelligent video analysis. Videos shall be
processed and analyzed within the camera itself, with no extra
hardware required. The video-based fire detection shall offer a
fast detection and high false alarm robustness with best picture
quality even at challenging light conditions. The video-resolution
shall be up to HD with activated video-based fire detection.
The video-based fire detection shall detect uncovered flames
with minimum 1.6% of the picture width. Uncovered uprising
smoke shall be detected with minimum 2.3% of the picture
width. The detection shall detect test fires TF1 to TF8 according
to EN54. For the detection of flames and smoke a minimum
illumination level of 7 Lux shall be sufficient.
The video-based fire detection shall be adaptable to
applications. The following settings shall be available: detection
size, sensitivity and masking.
For adoption to local conditions vario-focal lenses with
adjustable focal length can be used.
An object-oriented video analysis for indoor and outdoor
applications shall run in parallel to the video-based fire
detection within the camera itself. The video analysis shall
monitor 8 rules in parallel, like object in field, crossing line,
following route, idle object, loitering.
Results of the video-based fire detection and Intelligent Video
Analysis have to available as metadata in addition to the video
data transmitted for alerting, storage and forensic search.
The camera shall provide a relay output that may be selected
for normally opened or normally closed operation.
The camera shall provide the following features:
- The camera shall have a microSD card slot that uses
standard; off-the-shelf microSD (SDHC and SDXC) cards for
local storage (up to 1.2 TB)
- The camera shall transmit two H.264 streams with 30 frames
per second.
- The camera shall allow full camera control and configuration
capabilities over the network.
- The focus shall be set automatically.
- The camera shall support iSCSI devices to allow video stream
to be recorded directly to an iSCSI RAID array.
- The camera shall support 802.1x authentication using a
RADIUS (Remote Authentication Dial In User Service) server.
Technical Specifications
Power
Power Supply
12 VDC
Power-over-Ethernet 48 VDC nominal
Current Consumption
500 mA (12 VDC)
175 mA (PoE 48 VDC)
Power Consumption
9W
PoE
IEEE 802.3af (802.3at Type 1) Class 3
Sensor
Type
1/1.8-inch CMOS
Pixels
6.1MP
Video performance - Dynamic range
1080p mode
103 dB WDR
(103+16 dB with iAE)
Video performance – Sensitivity
(3200K, 89% reflectivity, 30% IRE, F1.2)
Color 1080p mode
0.00825 lx
Mono 1080p mode
0.00275 lx
Video streaming
Video compression
H.264 (ISO/IEC 14496-10); M- JPEG, JPEG
Streaming
Multiple configurable streams in H.264 and M-JPEG,
configurable frame rate and bandwidth.
Regions of Interest (ROI)
Overall IP Delay
Min. 120 ms, Max. 340 ms
GOP structure
IP, IBP, IBBP
Encoding interval
1 to 30 fps
Encoder regions
Up to 8 areas with encoder quality settings per
area
Video resolution
1080p HD
1920 X 1080
720p HD
1280 x 720
Video resolution
Upright 9:16 (cropped)
400 x 720
D1 4:3 (cropped)
704 x 480
480p SD
Encoding: 704 x 480;
Displayed: 854 x 480
432p SD
768 x 432
288p SD
512 x 288
240p SD
Encoding: 352 x 240;
Displayed: 432 x 240
144p SD
256 x 144
Video functions
Day/Night
Color, Monochrome, Auto
Adjustable picture settings
Contrast, Saturation, Brightness
White Balance
2500 to 10000K, 4 automatic modes (Standard, SON/SOX,
Basic, Dominant color), Manual mode and Hold mode
Shutter
Automatic Electronic Shutter (AES)
Fixed selectable
Default shutter
Backlight compensation
Off, Auto, intelligentAE (iAE)
Noise reduction
intelligent Dynamic Noise Reduction (iDNR) with separate
temporal and spatial adjustments
Contrast enhancement
On/off
Sharpness
Sharpness enhancement level selectable
Privacy Masking
Four independent areas, fully programmable
Video Motion Analysis
Intelligent Video Analysis (IVA)
User modes
9 modes
Other functions
Image flip, Pixel counter, Video watermarking, Display
stamping
Audio streaming
Standard
G.711, 8 kHz sampling rate
L16, 16 kHz sampling rate
AAC-LC, 48 kHz sampling rate
AAC-LC, 80 kHz sampling rate
Signal-to-Noise Ratio
>50 dB
Audio Streaming
Full-duplex / half duplex
Input/output
Analog video out
SMB connector, CVBS (PAL/NTSC), 1 Vpp, 75 Ohm
(service only)
Audio line in
1 Vrms max, 18 kOhm typical,
Audio line out
0.85 Vrms at 1.5 kOhm typical,
Audio connectors
3.5 mm mono jack
Alarm input
2 inputs
Alarm input activation
+5 VDC nominal; +40 VDC max. (DC-coupled with
50 kOhm pull-up resistor to +3.3 VDC)
(< 0.5 V is low; > 1.4 V is high)
Alarm output
1 output
Alarm output voltage
30 VAC or +40 VDC max.
Maximum 0.5 A continuous, 10VA (resistive load only)
Ethernet
RJ45
Data port
RS-232/422/485
Local storage
Internal RAM
10 s pre-alarm recording
Memory card slot
Supports SDHC and SDXC microSD cards
Recording
Continuous recording, ring recording.
alarm/events/schedule recording
Network
Protocols
IPv4, IPv6, UDP, TCP, HTTP, HTTPS, RTP/RTCP, IGMP
V2/V3, ICMP, ICMPv6, RTSP, FTP, Telnet, ARP, DHCP,
NTP (SNTP), 802.1x, DNS, DNSv6, DDNS (DynDNS.org,
selfHOST.de, no-ip.com), SMTP, iSCSI, UPnP (SSDP),
DiffServ (QoS), LLDP, SOAP, Dropbox, CHAP, digest
authentication
Encryption
TLS 1.0, SSL, DES, 3DES, AES (optional)
Ethernet
10/100 Base-T, auto-sensing, half/full duplex
Ethernet connector
RJ45
Connectivity
ONVIF Profile S, Auto-MDIX
Software
Unit Configuration
Via web browser or Configuration Manager
Software
Firmware update
Remotely programmable
Software viewer
Web browser, Bosch Video Client, or third party software
Optical
Lens mount
CS mount (C-mount with adapter ring)
Lens connector
Standard 4-pin DC-iris connector
Focus control
Motorized back-focus adjustment
Iris control
Automatic iris control
Mechanical
Dimensions (W x H x L)
78 x 66 x140 mm (3.07 x 2.6 x 5.52 inch) without lens
Weight
855 g (1.88 lb) without lens
Color
RAL 9006 Metallic Titanium
Tripod Mount
Bottom and top 1/4-inch 20 UNC
Environmental
Operating Temperature
-20°C to +50°C (-4°F to 122°F)
Storage Temperature
-30°C to +70°C (-22°F to +158°F)
Operating Humidity
20% to 93% RH
Storage Humidity
up to 98% RH
Storage Humidity
up to 98% RH
Sales text
F.01U.317.536; FCS-8000-VFD-B;
AVIOTEC IP starlight 8000
1080p network camera with integrated video-based fire
detection and simultaneous intelligent video analysis.
The video-base fire detection offers a fast detection and high
false alarm robustness with best picture quality even at
challenging light conditions down to 7 Lux. It allows a detection
of test fires compared to TF1 to TF8 according to EN54. For
adoption to local conditions vario-focal lenses with adjustable
focal length can be used. The alarm transmission will be done
either by Ethernet or dry contacts.
Offer text
F.01U.317.536; FCS-8000-VFD-B;
AVIOTEC IP starlight 8000
1080p network camera with integrated video-based fire
detection and simultaneous intelligent video analysis.
The video-base fire detection offers a fast detection and high
false alarm robustness with best picture quality even at
challenging light conditions down to 7 Lux. It allows a detection
of test fires compared to TF1 to TF8 according to EN54. For
adoption to local conditions vario-focal lenses with adjustable
focal length can be used. The alarm transmission will be done
either by Ethernet or dry contacts.
The video-based fire detection detects uncovered flames with
minimum 1.6% of the picture width. Uncovered uprising smoke
will be detected with minimum 2.3% of the picture width. The
video-based fire detection is adaptable to applications. The
following settings are available: detection size, sensitivity and
masking.
For adoption to local conditions vario-focal lenses with
adjustable focal length can be used.
An object-oriented video analysis for indoor and outdoor
applications runs in parallel to the video-based fire detection
within the camera itself. The video analysis monitors 8 rules in
parallel, like object in field, crossing line, following route, idle
object, loitering.
Results of the video-based fire detection and Intelligent Video
Analysis are available as metadata in addition to the video data
transmitted for alerting, storage and forensic search.
The camera provides a relay output that may be selected for
normally opened or normally closed operation.
×

Report this document