# 1.1.4.A Component Identification

#### Document technical information

Format docx
Size 2.8 MB
First found May 22, 2018

#### Document content analysis

Category Also themed
Language
English
Type
not defined
Concepts
no text concepts found

#### Transcript

```Activity 1.1.4 Component Identification: Analog
Introduction
In the field of electronics, there are an endless number of different types of components. The
ability to identify these components and to understand how they are labeled is an essential
skill for anyone working in the field.
In this activity you will identify and determine the nominal values for a series of resistors and
capacitors. We will concentrate on resistors and capacitors because they are part of virtually
Equipment




Scientific calculator
Digital multimeter (DMM)
Resistors
Capacitors
Procedure
1. Using the attached resistor color code, determine the nominal resistance value for the
following components. Express your answers using the proper SI units and prefix.
(Yellow / Violet / Red / Gold)
a) Ra = ____________________________
(Green / Blue / Yellow / Gold)
b) Rb = ____________________________
Digital Electronics Activity 1.1.4 Component Identification – Page 1
(Red / Violet / Brown / Gold)
c) Rc = ____________________________
(Brown / Red / Green / Gold)
d) Rd = ____________________________
(Blue / Gray / Orange / Gold)
e) Re = ____________________________
Digital Electronics Activity 1.1.4 Component Identification – Page 2
2. Obtain 10 random resistors from your instructor. Using the Resistor Color Code
Diagram, record each resistors nominal value and tolerance range. Next, use a digital
multi-meter (DMM) to measure and record the actual resistance value of each resistor.
Finally, indicate if the measured value is within acceptable tolerance.
Tolerance Range
Resistor
Colors
Nominal
Value
Minimum
Accepted
Value
Maximum
Accepted
Value
Measured
Value
Meets
Tolerance?
1
2
3
4
5
6
7
8
9
10
3. Use the attached Disc Capacitor Label Diagram to determine the nominal capacitance
value for the following components.
a) Ca = ____________________________
Digital Electronics Activity 1.1.4 Component Identification – Page 3
b) Cb =____________________________
c) Cc = ____________________________
d) Cd = ____________________________
e) Ce = ____________________________
Digital Electronics Activity 1.1.4 Component Identification – Page 4
Resistor Color Code Diagram
Disc Capacitor Label Diagram
Digital Electronics Activity 1.1.4 Component Identification – Page 5
Conclusion
1. Why are the measured values of the resistors different from the nominal values?
2. Identify each of the circled components for the printed circuit board shown below.
A. ________________________
B. ________________________
C. ________________________
D. ________________________
E. ________________________
F. ________________________
C
F
B
D
A
E